A room can look and feel dry to the touch while moisture meters still show trapped moisture inside wall cavities or under flooring.
We calculate air mover and dehumidifier placement using psychrometric formulas, not a flat per-room equipment count.
We calculate drying requirements using temperature and humidity data, not a flat per-room rule.
Low Grain Refrigerant dehumidifiers pull significantly more moisture from the air than consumer-grade units.
We map hidden moisture with thermal imaging before finalizing equipment placement.
Moisture readings are logged daily throughout the Structural Drying And Dehumidification job so progress is measurable, not assumed.
Here's the full scope of a Structural Drying And Dehumidification job in Hanscom AFB, from initial scan to final verification.
The assessment sets the baseline every later reading gets measured against.
Thermal cameras scan walls, ceilings, and flooring to reveal moisture invisible to the naked eye.
Dehumidifier capacity is matched to the calculated moisture load for that specific space.
Documented logs track the numbers from day one through final verification.
We adjust drying speed for sensitive materials like hardwood and cabinetry to prevent secondary damage.
We provide a written verification report confirming the structure has reached dry standard.
Tell our Hanscom AFB, MA dispatcher about the current condition so we can prepare the right diagnostic equipment.
Our nearest Hanscom AFB, MA crew brings diagnostic equipment loaded from the start.
We complete the psychrometric assessment and thermal scan, then provide a written drying plan and quote.
A written verification report backs the final sign-off.
"The thermal imaging found moisture behind a wall that looked completely fine from the outside. Would have missed it otherwise." — Julian R.
"They came back every single day to take readings and showed me the numbers improving. Felt like real science, not guesswork." — Monique T.
"Our hardwood floor didn't warp because they slowed the drying process down specifically for it." — Grant P.
A room can look dry on the surface while moisture meters still detect trapped moisture inside materials.
It's a calculated approach using temperature and humidity data to determine exact equipment needs, rather than guessing.
Typical drying time is 3-5 days for standard materials, longer for sensitive ones like hardwood.
You'll see the actual numbers improve each day through documented logs.
Yes, we use slower, controlled drying specifically calibrated for hardwood to prevent warping.
We reassess the plan, since stalled readings usually mean equipment placement or capacity needs adjusting, not just more time.
Hanscom AFB is within our core structural drying response zone.
Speak directly with our structural drying team.
Call +1-844-833-1325